Downlights
Today a considerable amount of homes feature halogen downlights, due to their modern slim line look, and the relatively low cost of purchase.

A downlight emits a small efficient and economical source of light suitable for use in many and varied applications. Where a softer light is required this can be achieved through installation of a dimming switch.

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player
B CH = Brushed Chrome • AB = Antique Brass • T/L = Touch Light • #LT = Number of Lights
Facts
Although halogens generally run a low wattage and are considered to be a low voltage light (they include a transformer that converts the electricity from 240v to the 12v) they are not effectively efficient to run. This is because more than not 4 to 6 downlights are used to light a room and this needs to be considered when purchasing downlights.

12v contain transformers, 240v do not. Consult with your electrician on spacing parameters or speak to us - must be installed as per SAA requirements.
Tips
Consider installing an infrared sensor when installing downlights for your passage, this will make sure the lights are not on when you're not in the vicinity

Before you install downlights, make sure there is enough ceiling room, downlights contain a transformer that must sit concealed inside the ceiling. Downlights need more head room than most other lighting fixtures.

Mark out the position of the downlights on the floor first with tape or chalk before transferring the position to the ceiling.

Selecting downlights that have pivoting lamps will allow you to position the beam of light on a focal point or position of the room.
Fire Hazard
In the past there have been concerns about downlights and the potential fire hazard they pose. Because halogens emit so much heat they are more dangerous than other lighting alternatives, although most insulation is fire-resistant or inflammable, there have been cases of housefires being caused from insulation being heated from downlights. In the past it has been recommended a 150mm gap be left between the downlight and insulation. This unfortunately reduces the effectiveness of ceiling insulation however. The best rule is to use a qualified electrician.